Refilling The Tape Sealant Bottle - Pitney Bowes Connect+ 500W Operator's Manual

2. Remove the cap from the bottle.
3. Add enough E-Z Seal® to bring the level up to the bottom of the throat of the bottle.
Do not overfill the envelope sealant bottle.
l
Make sure you do not spill any solution in the tape well. If the tape gets wet, it can
l
warp and cause a stoppage.
4. Replace and tighten the cap and return the bottle to its original position.
5. Close the supplies cover.

Refilling the Tape Sealant Bottle

Refill the tape sealant bottle when your E-Z Seal® Sealing Solution is running low.
NOTE: Pitney Bowes recommends using E-Z Seal® Sealing Solution because it helps
keep your moistener tank clean and improves sealing performance.
1. Lift the tape sealant bottle out of the cradle. The bottle is located to the right of the printer
module, behind the stacker.
2. Remove the cap from the bottle.
3. Add enough E-Z Seal® to bring the level up to the bottom of the throat of the bottle. Do
not overfill the envelope sealant bottle.
4. Replace and tighten the cap and return the bottle to its original position.
SV62589 Rev. C
Connect+® Series Operator Guide
171