Ip Proxy-Arp; Ip Routing Commands; Table 4-82 Ip Routing Commands - Edge-Core ES3628C Management Manual

4
Command Line Interface

ip proxy-arp

This command enables proxy Address Resolution Protocol (ARP). Use the no form
to disable proxy ARP.
Syntax
[no] ip proxy-arp
Default Setting
Disabled
Command Mode
Interface Configuration (VLAN)
Command Usage
Proxy ARP allows a non-routing device to determine the MAC address of a
host on another subnet or network.
Example
Console(config)#interface vlan 3
Console(config-if)#ip proxy-arp
Console(config-if)#

IP Routing Commands

After you configure network interfaces for this router, you must set the paths used to
send traffic between different interfaces. If you enable routing on this device, traffic
will automatically be forwarded between all of the local subnetworks. However, to
forward traffic to devices on other subnetworks, you can either configure fixed paths
with static routing commands, or enable a dynamic routing protocol that exchanges
information with other routers on the network to automatically determine the best
path to any subnetwork.
This section includes commands for both static and dynamic routing. These
commands are used to connect between different local subnetworks or to connect
the router to the enterprise network.
Command Group
Global Routing
Configuration
Routing Information
Protocol (RIP)
Open Shortest Path First
(OSPF)
4-250

Table 4-82 IP Routing Commands

Function
Configures global parameters for static and dynamic routing, displays the
routing table, and statistics for protocols used to exchange routing
information
Configures global and interface specific parameters for RIP
Configures global and interface specific parameters for OSPF
Page
4-251
4-256
4-266