Adjusting The Tension Of The Stack Processing Motor Belt - Toshiba e-studio200l Service Manual

3.12.4

Adjusting the tension of the stack processing motor belt

<Procedure>
(1) Remove the right inner cover and the rear cover.
(2) Remove the 2 mounting screws, and detach
the grip unit.
(3) Loosen the screw on the tension arm plate.
(The tension arm plate will be pulled under
tension by the tension spring.)
(4) Move the returning roller shaft to its lower
limit (the slack of a belt is lightly taken); then,
tighten the screw on the tension arm plate.
e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT
Screw
Screw
Tension arm
plate
Screw
Tension arm
plate
3 - 88
Grip unit
Screw
Fig.3-118
Fig.3-119
Returning
roller shaft
Fig.3-120
June 2004 © TOSHIBA TEC