[ 2 ] Paper jam in puncher unit
[E9F0]
Punching jam
MJ-1025
Is there any paper remaining on the transport path in the finisher or equipment?
YES Æ Remove the paper.
È
NO
Is the connector J1006 on the punch controller PC board disconnected?
Is the harness connecting the punch controller PC board and punch home position sensor
(PI1P) open circuited?
YES Æ Connect the connector securely. Replace the harness.
È
NO
Is the punch home position sensor working properly?
NO Æ
l
È
YES
Replace the punch controller PC board.
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
1) Connect the connector of the punch home position sensor securely.
2) Replace the punch home position sensor.
5 - 36
June 2004 © TOSHIBA TEC