Toshiba e-studio200l Service Manual page 627

*When the updating of the NIC firmware is failed, an error message is displayed as the figure
below. Turn OFF the power and then check the above-mentioned items. After confirming
them, select only "4. NIC Firmware Update" and restart updating from the beginning. This
may complete the updating properly.
If the updating of the NIC firmware is still failed, check the prescription corresponding to the error
message. After confirming and clearing the problem, restart updating from the beginning.
NIC Error Message
NIC UPDATE FAILED 1 NIC initialization time-out
NIC UPDATE FAILED 2 ATA driver initialization error
NIC UPDATE FAILED 3 HDD partition mount error
NIC UPDATE FAILED 4 NIC setting information backup error
NIC UPDATE FAILED 5 NIC firmware transfer error
NIC UPDATE FAILED 6 NIC firmware writing error
NIC UPDATE FAILED 7 NIC status time-out
Note: Note:
If the updating of the NIC firmware is not completed properly, wait 5 minutes or more from the
beginning of the updating before turning OFF the power, and then restart updating from the
beginning. If you turn OFF the power within 5 minutes, HDD may be destroyed.
June 2004 © TOSHIBA TEC
Fig.6-78
Error Contents
e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING
6 - 73
04/09
Prescription
The IP address may not be assigned cor-
rectly.
• Is the IP address assigned correctly?
• Does the IP address conflict with the
other system?
If the error still occurs, replace the NIC
board because it may be destroyed.
The HDD cable may be disconnected.
• Is the HDD cable connected correctly?
If the HDD cable is connected correctly,
replace the SYS board because it may be
destroyed.
Replace the HDD because it may be
destroyed.
Replace the HDD because it may be
destroyed.
Replace the NIC board because it may be
destroyed.
Replace the NIC board because it may be
destroyed.
Replace the NIC board because it may be
destroyed.
6