Toshiba e-studio200l Service Manual page 495

[Procedure 2]
Is the staple/fold motor clock sensor (PI14) working properly?
NO Æ
È
YES
Does the staple/fold motor operate at the appropriate timing?
YES Æ Replace the finisher controller PC board.
È
NO
Is the stapler unit drive mechanism working properly?
NO Æ
È
YES
Try replacing the staple/fold motor (M7). Is the problem corrected?
YES Æ End.
È
NO
Replace the finisher controller PC board.
[Procedure 3]
Is the folding home position sensor (PI11) working properly?
NO Æ
È
YES
Is the wiring between the finisher controller PC board and the staple/fold motor normal?
NO Æ
È
YES
Try to rotate the fold jam releasing dial. Is there mechanical trapping?
YES Æ Fix the mechanism.
È
NO
Try replacing the staple/fold motor (M7). Is the problem corrected?
YES Æ End.
È
NO
Replace the finisher controller PC board.
June 2004 © TOSHIBA TEC
Replace the sensor.
Fix the mechanism.
Replace the sensor.
Correct the wiring.
5 - 65
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5