[EAF0] Stack return jam
MJ-1022
Is there any paper remaining on the transport path in the finisher or equipment?
YES Æ Remove the paper.
È
NO
Is the connector J10 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and returning roller home position
sensor (S3) open circuited?
YES Æ Connect the connector securely. Replace the harness.
È
NO
Is the returning roller home position sensor working properly?
NO Æ
l
l
È
YES
Replace the finisher controller PC board.
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
1) Connect the connector of the returning roller home position sensor
securely.
2) Replace the returning roller home position sensor.
5 - 44
June 2004 © TOSHIBA TEC