Toshiba e-studio200l Service Manual page 497

[CB80] Backup RAM data abnormality
MJ-1025
Is the problem solved by turning the power of the equipment OFF and ON?
YES Æ End.
È
NO
1) Replace the finisher controller PC board.
2) Replace the punch controller PC board.
[CC30] Stack processing motor abnormality/Paddle motor abnormality
MJ-1022 (Stack processing motor abnormality)
[Procedure 1]
Is the tension of the drive belt normal?
NO Æ
È
YES
Does the bushing attached to the returning roller shaft smoothly move up and down?
NO Æ
È
YES
Is the spring of the returning roller detached?
YES Æ Attach the spring.
È
NO
Is the wiring between the finisher controller PC board and stack delivery motor (M2) cor-
rect?
NO Æ
È
YES
Is the stack delivery lever home position sensor (S8) working properly?
NO Æ
È
YES
1) Replacing the stack processing motor.
2) Replace the finisher controller PC board.
June 2004 © TOSHIBA TEC
Loosen the adjustment screw to adjust its tension.
Apply grease on the cut-out part of the front side frame where the bush-
ing contacts.
Correct the wiring.
Replace the sensor.
5 - 67
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5