Toshiba e-studio200l Service Manual page 557

Multifunctional digital systems
Hide thumbs Also See for e-studio200l:
Table of Contents

Advertisement

Connector
( for SYS board
connection )
ROM4
ROM5
ROM6
Fig.6-1 Jig board: PWA-DWNLD-350-JIG2 (48 MB)
Important:
The download jig (PWA-DWNLD-350-JIG) has two types having different ROM capacity.
ROM capacity for each jig is as follows.
Download jig
PWA-DWNLD-350-JIG2 (48 MB)
PWA-DWNLD-350-JIG1 (16 MB)
* "PWA-DWNLD-350-JIG2 (48 MB)" is substitutable for "PWA-DWNLD-350-JIG1 (16 MB)"
The download jig (PWA-DWNLD-350-JIG) is different type jig. The Flash ROM is installed on
the board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the
data to these Flash ROMs. Refer to the following to write the data.
P.6-20 "6.1.3 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
Important:
Pay attention to the direction of the ROM.
June 2004 © TOSHIBA TEC
Connector
( for ROM writer
adapter connection )
ROM1
ROM2
ROM3
ROM capacity
8 MB x 6
8 MB x 2
Connector
Mark for ROM
installation direction
Fig.6-3 Jig board: K-PWA-DLM-320
6 - 3
Connector
Connector
( for SYS board
( for ROM writer
connection )
adapter connection )
Fig.6-2 Jig board: PWA-DWNLD-350-JIG1 (16 MB)
Application
Updating the master data
Updating the system ROM, engine ROM,
scanner ROM, NIC ROM
LED
ROM
e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING
ROM1
ROM2
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents