Toshiba e-studio200l Service Manual page 621

Important:
• The following USB storage devices are recommended for updating.
- MELCO
- Lexar Media
- Iomega
• Only the USB storage device which meets the following conditions should be used for updat-
ing. Be careful since updating with any device other than the above is never guaranteed.
- A combination USB storage device with a flash memory (to be connected directly to the
USB port) and its capacity is 64 MB or more
- A USB storage device which is complied with the following standards regulated by USB-IF
(USB Implementers Forum)
Class number:
Sub-class number: 6 (=06h)
Protocol number: 80 (=50h)
* Most common USB storage devices are complied with the specification above and can be
used for updating. However, the operation in this equipment is not always guaranteed
since the most of these devices are developed based on the use in PC environment (Win-
dows or Macintosh).
Therefore, confirm thoroughly that the device is operational in this equipment when pur-
chasing the device.
• The USB storage device complied with USB1.1 and USB2.0 can be used for updating. How-
ever, the update is performed in the speed of USB1.1 when the device complied with USB2.0
is used.
• Do not update the firmware by any storage device other than a flash memory (such as a USB
connection type memory card reader, CD/DVD drive or hard disk) since it is never guaran-
teed.
[A] Update procedure
Important:
• The file system of USB storage device should be formatted in FAT format. Be careful since
the devices formatted in FAT32 or NTFS format will not be operated. The file system can be
confirmed on the properties in applications such as Explorer of Windows.
• Do not turn OFF the power during the update. The data could be damaged and not to be
operated properly.
(1) Connect the USB storage device to the PC and write the data file.
• Confirm the data file name before writing (
age Device (e-STUDIO200L/230/280)").
• The file system of USB storage device should be formatted in FAT format.
• Windows 95 and NT do not support USB. Be careful since the data can not be written on the
devices in the PCs with these operating systems.
(2) Turn OFF the power of equipment.
June 2004 © TOSHIBA TEC
ClipDrive (RUF-C128M)
JumpDrive (RD128-231)
Mini USB Drive (Mini 128 MB USB Drive)
8 (=08h) (Mass-storage class)
(SCSI transfer command set)
(Bulk-Only)
6 - 67
04/09
P.6-66 "6.4 Firmware Updating with USB Stor-
e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING
6