Toshiba e-studio200l Service Manual page 40

Error code Classification
E711 RADF jam
E712
E713
E714
E721
E722
E723
E724
E725
E726
E731
E741
E742
E743
E860
E870
e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
Jam not reaching the original length sensor: The
original fed from the original feeding tray does not
reach the original length sensor.
Jam not reaching the registration sensor: The origi-
nal fed from the original feeding tray does not reach
the registration sensor.
Stop jam at the original length sensor: The trailing
edge of the original does not pass the original
length sensor after its leading edge has reached
this sensor.
Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
Jam not reaching the exit sensor (during scanning):
The original which passed the read sensor does not
reach the exit sensor when it is transported from the
scanning section to exit section.
Jam not reaching the reverse sensor (during scan-
ning): The original which passed the read sensor
does not reach the reverse sensor when it is trans-
ported from the scanning section to reverse section.
Stop jam at the registration sensor: The trailing
edge of the original does not pass the registration
sensor after its leading edge has reached this sen-
sor.
Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its lead-
ing edge has reached this sensor.
Transport/exit signal reception jam: RADF receives
the transport/exit reception signal from the equip-
ment when no original is at the exposure waiting
position.
Stop jam at the exit sensor: The trailing edge of the
original does not pass the exit sensor after its lead-
ing edge has reached this sensor.
Stop jam at the reverse sensor: The trailing edge of
the original does not pass the reversal sensor after
its leading edge has reached this sensor.
Jam not reaching the reverse sensor (during
reverse feeding): The leading edge of the original
does not reach the reverse sensor when original is
fed from the reverse section.
Jam not reaching the exit sensor (during reverse
feeding): The original does not reach the exit sen-
sor after it has passed the reverse sensor when the
original is exited from the reverse section.
RADF jam access cover open: The RADF jam
access cover has opened during RADF operation.
RADF open jam: RADF has opened during RADF
operation.
2 - 4
Troubleshooting
P. 5-28
P. 5-28
P. 5-28
P. 5-29
P. 5-29
P. 5-30
P. 5-30
P. 5-30
P. 5-31
P. 5-31
P. 5-32
P. 5-32
P. 5-33
P. 5-33
P. 5-34
P. 5-34
June 2004 © TOSHIBA TEC