Toshiba e-studio200l Service Manual page 472

[EA60] Early arrival jam
MJ-1022
Is there any paper remaining on the transport path in the finisher or equipment?
YES Æ Remove the paper.
È
NO
Is the connector J10 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor (S2) open cir-
cuited?
YES Æ Connect the connector securely. Replace the harness.
È
NO
Is the inlet sensor working properly? (Check the movement of the actuator.)
NO Æ
l
l
È
YES
Replace the finisher controller PC board.
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
1) Connect the connector of the inlet sensor securely.
2) Attach the actuator securely if its shaft is out of place.
3) Replace the inlet sensor.
5 - 42
June 2004 © TOSHIBA TEC