Toshiba e-studio200l Service Manual page 440

[E550] Paper remaining on the transport path
Open the cover of the unit/area whose picture is blinking on the control panel. Is there any
paper on the transport path?
YES Æ Remove the paper.
È
NO
Is the sensor in the jamming area working? (Perform the input check in the test mode: refer
to the following table)
l NOÆ
l
l
l
l
l
l
l
È
YES
Replace the LGC board.
Relation between the jamming area and the corresponding sensors/covers
(If a jam is occurring in the ADU, LCF, PFP, JSP or OCT check the board in each unit.)
Jamming area
Registration area
Exit area
ADU
Feeding area
(Main unit)
LCF
PFP
Bridge unit
JSP
OCT
Finisher
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
1) Check if the connector of the sensor is disconnected.
2) Check if any of the connectors on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the sensor.
6) Replace the LGC board.
Cover
Transfer cover Registration sensor
1st transport sensor
Transfer cover Exit sensor
ADU ADU entrance sensor
ADU exit sensor
Side cover 2nd transport sensor
LCF side cover LCF feed sensor
PFP side cover PFP upper drawer feed sensor
PFP lower drawer feed sensor
Bridge unit Bridge unit transport sensor-1
Bridge unit transport sensor-2
JSP cover JSP feed sensor
OCT cover OCT feed sensor
Finisher door Sensors in the finisher
Sensor
5 - 10
Test mode/Input check
03-[FAX]ON/[2]/[A]
03-[FAX]OFF/[6]/[E]
03-[FAX]ON/[2]/[B]
03-[FAX]OFF/[1]/[H]
03-[FAX]OFF/[1]/[G]
03-[FAX]OFF/[7]/[E]
03-[FAX]OFF/[5]/[G]
03-[FAX]OFF/[2]/[D]
03-[FAX]OFF/[4]/[D]
03-[FAX]ON/[3]/[H]
03-[FAX]ON/[3]/[E]
03-[FAX]ON/[3]/[H]
03-[FAX]ON/[3]/[H]
-
June 2004 © TOSHIBA TEC