Toshiba e-studio200l Service Manual page 460

[E722] Jam not reaching the exit sensor (during scanning)
[E723] Jam not reaching the reverse sensor (during scanning)
Is the read roller stained?
YES Æ Clean the roller.
È
NO
Are the exit sensor and reverse sensor working?
(Perform the input check: 03-[FAX]ON/[7]/[E], /[7]/[F])
NO Æ
l
l
l
l
l
l
l
l
l
È
YES
Replace the RADF board.
[E724] Stop jam at the registration sensor
Is the registration roller stained?
YES Æ Clean the roller.
È
NO
Is the registration sensor working? (Perform the input check: 03-[FAX]ON/[7]/[H])
NO Æ
l
l
l
l
l
l
l
l
È
YES
Replace the RADF board.
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
1) Check if the connectors of the exit sensor and reverse sensor are
disconnected.
2) Check if the connector CN4 on the RADF board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are
open circuited.
4) Check if the conductor pattern on the RADF board is short circuited
or open circuited.
5) Replace the exit sensor and reverse sensor.
6) Replace the RADF board.
1) Check if the connector of the registration sensor is disconnected.
2) Check if the connector CN3 on the RADF board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are
open circuited.
4) Check if the conductor pattern on the RADF board is short circuited
or open circuited.
5) Replace the registration sensor.
6) Replace the RADF board.
5 - 30
June 2004 © TOSHIBA TEC