Toshiba e-studio200l Service Manual page 496

[Procedure 4]
Is the staple/fold motor clock sensor (PI14) working properly?
NO Æ
È
YES
Does the staple/fold motor operate at the appropriate timing?
YES Æ Replace the finisher controller PC board.
È
NO
Is the saddle stitch unit drive mechanism working properly?
NO Æ
È
YES
Try replacing the staple/fold motor (M7). Is the problem corrected?
YES Æ End.
È
NO
Replace the finisher controller PC board.
[CB60] Stapler unit shift motor abnormality
MJ-1025
Is the slide home position sensor (PI18) working properly?
NO Æ
È
YES
Is the wiring between the finisher controller PC board and slide motor correct?
NO Æ
È
YES
Is there any mechanical problem with the stapler stand motion path?
YES Æ Fix the mechanism.
È
NO
Try replacing the slide motor (M8). Is the problem corrected?
YES Æ End.
È
NO
Replace the finisher controller PC board.
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
Replace the sensor.
Fix the mechanism.
Replace the sensor controller PC board.
Correct the wiring.
5 - 66
June 2004 © TOSHIBA TEC