Toshiba e-studio200l Service Manual page 82

Notes:
• The digit after the hyphen in "Code" of the following table is a sub code.
• In "RAM", the NVRAM of the board in which the data of each code is stored is indicated. "M"
stands for the LGC board and "SYS" stands for the SYS board.
Classi-
Code
fication
200 Devel- Automatic adjustment of
oper auto-toner sensor
(Fuser heater ON)
201 Devel- Correction of auto-toner
oper sensor
(Fuser heater ON)
205 Devel- Developer bias DC output
oper adjustment
210 Charger Main charger grid bias out-
put adjustment
220 Transfer Transfer transformer DC
output adjustment (H)
221 Transfer Transfer transformer DC
output adjustment (C)
222 Transfer Transfer transformer DC
output adjustment (L)
233 Separa- Separation transformer DC
tion output adjustment (H)
234 Separa- Separation transformer DC
tion output adjustment (C)
235 Separa- Separation transformer DC
tion output adjustment (L)
280 Process Forced performing of idling
for toner recycle
286 Laser Laser power adjustment
305 Scanner Image location adjustment
of secondary scanning
direction
(scanner section)
e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE
Adjustment mode (05) <e-STUDIO200L/230/280>
Func-
Items
tion
ALL
ALL
ALL
ALL
ALL
ALL
ALL
ALL
ALL
ALL
ALL
ALL
ALL
2 - 46
05/12
Default
<Accept-
RAM
able
value>
- - As the value increases,
the sensor output
increases correspond-
ingly.
The value starts chang-
ing approx. 2 minutes
after this adjustment was
started and is automati-
cally set in the range of
2.35 to 2.45 V.
* Selection is disable
when developer unit
is not installed.
(Chap. 3.1)
164 M Corrects the control
<0-255> value of the auto-toner
sensor setup in 05-200.
* Selection is disable
when developer unit
is not installed.
135 M As the value increases,
<0-255> the transformer output
increases correspond-
90 M
ingly. Remove the devel-
<0-255>
oper unit and install the
165 M
adjustment jig to make
<0-255>
adjustment.
179 M
(Chap. 3.6)
<0-255>
126 M
<0-255>
64 M
<0-255>
65 M
<0-255>
46 M
<0-255>
- M Perform this adjustment
before the replacement
of the developer mate-
rial. (The toner is forcibly
removed from the
cleaner.)
63 M When the value
<0-255> increases, the laser out-
put increases corre-
spondingly.
125 SYS When the value
<92-164> increases by "1", the
image shifts by approx.
0.137 mm toward the
trailing edge of the
paper.
Proce-
Contents
dure
17
3
3
3
3
3
3
3
3
3
6
3
1
June 2004 © TOSHIBA TEC