Toshiba e-studio200l Service Manual page 492

[CB20] Delivery motor abnormality
MJ-1022
Rotate the delivery roller by hand. Does it rotate smoothly?
NO Æ
È
YES
Is the wiring between the finisher controller PC board and delivery motor (M1) correct?
NO Æ
È
YES
Is the delivery motor clock sensor (S1) working properly?
NO Æ
È
YES
1) Replace the delivery motor (M1).
2) Replace the finisher controller PC board.
MJ-1025
Is the delivery belt home position sensor (PI7) working properly?
NO Æ
È
YES
Is the wiring between the finisher controller PC board and delivery motor (M3) correct?
NO Æ
È
YES
Rotate the stack delivery roller by hand. Does it rotate smoothly?
NO Æ
È
YES
Try replacing the delivery motor (M3). Is the problem corrected?
YES Æ END.
È
NO
Replace the finisher controller PC board.
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
Fix the mechanism.
Correct the wiring.
Replace the sensor.
Replace the sensor.
Correct the wiring.
Fix the mechanism.
5 - 62
June 2004 © TOSHIBA TEC