3.11 Adjustment of the RADF (MR-3020)
3.11.1
Adjustment of RADF Position
Perform this adjustment when the RADF is not installed in the correct position.
Note:
Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF.
[A]
Checking
(1)
Open the RADF and install 2 positioning pins
(the positioning pins are installed to the back
side of the hinge which is on the left side of
the RADF).
(2)
Remove the platen sheet.
June 2004 © TOSHIBA TEC
Fig.3-79
Fig.3-80
e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT
3 - 69
05/11
3