Toshiba e-studio200l Service Manual page 471

[EA50] Stapling jam
MJ-1022
Is there any paper remaining on the transport path in the finisher or equipment or on the sta-
pling tray?
YES Æ Remove the paper.
È
NO
Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple
sheet slid from the staple case?
YES Æ End.
È
NO
Is the connector J8 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and stapling home position sen-
sor (S17) open circuited?
YES Æ Connect the connector securely. Replace the harness.
È
NO
Is the stapling home position sensor working properly?
NO Æ
l
È
YES
Replace the finisher controller PC board.
MJ-1025
Is there any paper remaining on the stapling tray?
YES Æ Remove the paper.
È
NO
Open the front door. Is the stapler home position mark blue?
YES Æ Rotate the stapler opening dial until the home position mark turns blue.
È
NO
Is any of the connectors CN11 (slide home position sensor), CN8 (stapler safety switch) and
CN6 (staple/fold motor) on the finisher controller PC board disconnected?
Is the stapler unit installed securely?
Is the harness connecting the finisher controller PC board and slide home position sensor
open-circuited?
Is the harness connecting the finisher controller PC board and stapler safety switch open-
circuited?
YES Æ Connect the connector securely. Replace the harness.
È
NO
Are the slide home position sensor and stapler safety switch working properly?
NO Æ
l
È
YES
Replace the finisher controller PC board.
June 2004 © TOSHIBA TEC
1) Connect the connector of the stapling home position sensor securely.
2) Replace the stapling home position sensor.
1) Replace the stapler unit.
2) Replace the stapler safety switch.
5 - 41
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5