Toshiba e-studio200l Service Manual page 447

[E130] Upper drawer misfeeding (paper not reaching the 1st transport sensor)
Open the transfer cover. Is there any paper in front of the 1st transport sensor?
YES Æ Remove the paper.
È
NO
Is the 1st transport sensor working?
(Perform the input check in the test mode: 03-[FAX]OFF/[6]/[E])
NO Æ
l
l
l
l
l
l
l
l
È
YES
Is the upper drawer feed clutch working?
(Perform the output check in the test mode: 03-201)
NO Æ
l
l
l
l
l
l
l
l
l
È
YES
Check the upper drawer feed roller, separation roller and pickup roller.
Replace them if they are worn out.
June 2004 © TOSHIBA TEC
1) Check if the connector of the 1st transport sensor is disconnected.
2) Check if the connector CN305 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the 1st transport sensor.
6) Replace the LGC board.
1) Check if the connector of the upper drawer feed clutch is discon-
nected.
2) Check if the connector CN307 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5) Replace the upper drawer feed clutch.
6) Replace the LGC board.
5 - 17
e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5