Toshiba e-studio200l Service Manual page 581

<Updating Finisher ROM>
(1) Install the ROM to the download jig.
Make sure the direction is correct (P.6-3 "Fig.6-3").
(2) Turn OFF the power of the equipment.
(3) Take off the finisher rear cover.
*Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4) Connect the download jig with the jig connector on the finisher control PC board.
June 2004 © TOSHIBA TEC
Finisher rear cover
Fig.6-29
Connector
Fig.6-30
e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING
6 - 27
6