After Replacing The Eep-Rom (Ic1002 Electrical System (Puncher Unit; Option)) - Toshiba e-studio200l Service Manual

3.13.4 After replacing the EEP-ROM (IC1002) (Electrical system
(Puncher unit; option))
<Procedure>
(1) Turn off the host machine.
(2) Set bits 1 through 4 on the punch controller PCB as follows:
(3) Press SW1002 and SW1003 on the punch controller PCB at the same time.
• The presses will initialize the EEP-ROM. At the end, all LEDs (LED1001, LED1002,
LED1003) will go ON.
(4) Adjust the sensor output, and store the number of punch holes.
e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT
ON
1 2 3 4
Fig.3-132
3 - 98
June 2004 © TOSHIBA TEC