Toshiba e-studio200l Service Manual page 84

Classi-
Code
fication
367 RADF RADF original guide width
adjustment
(Minimum)
368 RADF RADF original guide width
adjustment
(Maximum)
401 Laser Fine adjustment of polygo-
nal motor rotation speed
(adjustment of primary
scanning direction repro-
405
duction ratio)
410 Laser Adjustment of primary
scanning laser writing start
position.
411
421 Drive Adjustment of secondary
scanning direction repro-
duction ratio
(fine adjustment of main
422
motor speed)
424 Drive Fine adjustment of exit
motor speed
425
e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE
Adjustment mode (05) <e-STUDIO200L/230/280>
Func-
Items
tion
ALL
ALL
PRT
PPC
PPC
PRT
PPC/
PRT
FAX
PPC/
PRT
FAX
2 - 48
04/09
Default
<Accept-
RAM
able
value>
- - Stores the current width
of RADF original guide
by keying in this code
with the guide set at the
minimum width. Perform
this adjustment when the
RADF board or volume is
replaced, or when the
code (05-356) is per-
formed.
- - Stores the current width
of RADF original guide
by keying in this code
with the guide set at the
maximum width. Per-
form this adjustment
when the RADF board or
volume is replaced, or
when the code (05-356)
is performed.
136 M When the value
<0-255> increases by "1", the
reproduction ratio of pri-
mary scanning direction
134 M
increases by approx.
<0-255>
0.07%. (approx. 0.1 mm/
step)
128 M When the value
<0-255> increases by "1", the writ-
ing start position shifts to
153 M
the front side by approx.
<0-255>
0.0423 mm.
129 M When the value
<0-255> increases by "1", the
reproduction ratio of sec-
ondary scanning direc-
139 M
tion increases by approx.
<0-255>
0.04%.
160 M When the value
<0-255> increases by "1", the
rotation becomes faster
121 M
by approx. 0.05%.
<0-255>
Proce-
Contents
dure
6
6
1
1
1
1
1
1
1
1
June 2004 © TOSHIBA TEC