REP 3.4 Outer Duplex Guide
Parts List on
PL 3.1 Item 4
Removal
1.
Open the Front Door.
2.
Remove the Control Panel Cover
(REP
3.
Remove the Left Side Cover
(REP
1.10).
4.
Remove the Right Side Cover
(REP
5.
Lift and let the Control Panel hang on the right side of the printer.
6.
Disconnect the wiring harness connector
7.
Remove the 4 screws (plastic, T-20) that secure the Outer Duplex Guide to the chassis.
8.
Lift and remove the Outer Duplex Guide.
Figure 1 Removing the Outer Duplex Guide
Xerox Internal Use Only - Revised, 3rd Revision
ColorQube 8570/8870 Service Manual
1.5).
1.11).
P/J101
from the I/O Board.
REP 3.5 Upper Duplex Guide and Solenoid
Parts List on
PL 3.1 Item 5
Removal
1.
Open the Front Door.
2.
Remove the Control Panel Cover
3.
Remove the Left Side Cover
4.
Remove the Right Side Cover
5.
Lift and let the Control Panel hang on the right side of the printer.
6.
Remove the Outer Duplex Guide
7.
Disconnect the Solenoid wiring harness connector
Figure 1 Disconnecting Wiring Harness Connector from Right Side Harness
October 2012
4-57
(REP
1.5).
(REP
1.10).
(REP
1.11).
(REP
3.4).
P/J121
from the Right Side Harness.
Repairs and Adjustments
REP 3.4, REP 3.5