Using The Web Interface - Edge-Core ECS4620-28T Quick Start Manual

2
Connecting to the Web Interface

Using the Web Interface

This switch provides an embedded HTTP web agent. Using a web browser you can
configure the switch and view statistics to monitor network activity. The web agent
can be accessed by any computer on the network using a standard web browser
(Internet Explorer 6, Mozilla Firefox 4, or Google Chrome 29, or more recent
versions).
Note: You can also use the Command Line Interface (CLI) to manage the switch
over a serial connection to the console port or via Telnet. For more information on
using the CLI, refer to the CLI Reference Guide.
Prior to accessing the switch from a web browser, be sure you have first performed
the following tasks:
1.
Configure the switch with a valid IP address, subnet mask, and default gateway
using an out-of-band serial connection, BOOTP or DHCP protocol. (See "Initial
Switch Configuration" in the CLI Reference Guide.)
2.
Set user names and passwords using an out-of-band serial connection. Access
to the web agent is controlled by the same user names and passwords as the
onboard configuration program. (See
page 294.)
3.
After you enter a user name and password, you will have access to the system
configuration program.
Note: You are allowed three attempts to enter the correct password; on the third
failed attempt the current connection is terminated.
Note: If you log into the web interface as guest (Normal Exec level), you can view
the configuration settings or change the guest password. If you log in as "admin"
(Privileged Exec level), you can change the settings on any page.
Note: If the path between your management station and this switch does not pass
through any device that uses the Spanning Tree Algorithm, then you can set the
switch port attached to your management station to fast forwarding (i.e., enable
Admin Edge Port) to improve the switch's response time to management
"Configuring User Accounts" on
– 55 –