Mac Notification Commands - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The MAC Notification commands in the Command Line Interface (CLI) are listed, in the following table, along with their
appropriate parameters.
Command
enable mac_notification
disable mac_notification
config mac_notification
config mac_notification ports
show mac_notification
show mac_notification ports
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable MAC notification without changing basic configuration:
DES-3200-28:4#enable mac_notification
Command: enable mac_notification
Success.
DES-3200-28:4#
disable mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable MAC notification without changing basic configuration:
Parameters
{interval <int 1-2147483647> | historysize <int 1-500>} (1)
[<portlist> | all] [enable | disable]
{<portlist>}
Used to enable global MAC address table notification on the Switch.
enable mac_notification
This command is used to enable MAC address notification without
changing configuration.
None.
Only Administrator-level users can issue this command.
Used to disable global MAC address table notification on the Switch.
disable mac_notification
This command is used to disable MAC address notification without
changing configuration.
None.
Only Administrator-level users can issue this command.
MAC N
OTIFICATION
250
29
C
OMMANDS