Mac Notification Commands; Enable Mac_Notification; Disable Mac_Notification - D-Link DES-1210-52/ME Cli Reference Manual

The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
enable
mac_notification
disable
mac_notification
config mac_notification
config mac_notification
ports
show mac_notification
show mac_notification
ports
Each command is listed in detail, as follows:

enable mac_notification

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable MAC notification without changing basic configuration:

disable mac_notification

Purpose
Syntax
Description
DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide

MAC NOTIFICATION COMMANDS

Parameter
[interval <int 1-2147483647> | historysize <int 1-500>]
[<portlist> | all] [enable | disable]
{<portlist>}
Used to enable global MAC address table notification on the Switch.
enable mac_notification
The enable mac_notification command is used to enable MAC
address notification without changing configuration.
None.
Only administrator or operator-level users can issue this command.
DES-1210-52/ME:5# enable mac_notification
Command: enable mac_notification
Success.
DES-1210-52/ME:5#
Used to disable global MAC address table notification on the Switch.
disable mac_notification
The disable mac_notification command is used to disable MAC
253
34