Bpdu Attack Protection Commands - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The BPDU Attack Protection commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
config bpdu_protection ports
config bpdu_protection recovery_timer
config bpdu_protection
enable bpdu_protection
disable bpdu_protection
show bpdu_protection
Each command is listed, in detail, in the following sections:
Note: The BPDU Attack Protection function and Spanning Tree Protocol for ports are mutually
exclusive. When the STP function is enabled on a particular port, BPDU Attack Protection cannot be
enabled. If BPDU Attack Protection function is enabled on a port, BPDU cannot be forwarded.
BPDU A
TTACK
Parameters
[<portlist> | all ] {state [enable | disable] | mode [ drop | block |
shutdown } (1)
[<sec 60-1000000> | infinite]
[ trap | log ] [ none | attack_detected | attack_cleared | both ]
{ ports {<portlist> } }
485
P
ROTECTION
57
C
OMMANDS