Dhcp Relay Commands - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The DHCP Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
config dhcp_relay
config dhcp_relay add ipif
config dhcp_relay delete ipif
config dhcp_relay option_82 state
config dhcp_relay option_82 check
config dhcp_relay option_82 policy
config dhcp_relay option_82
remote_id
show dhcp_relay
enable dhcp_relay
disable dhcp_relay
Each command is listed in detail in the following sections:
config dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config DHCP relay:
DES-3200-28:4#config dhcp_relay hops 2 time 23
Command: config dhcp_relay hops 2 time 23
Success.
DES-3200-28:4#
Parameters
{hops <value 1-16> | time <sec 0-65535>} (1)
[System] <ipaddr>
[System] <ipaddr>
[enable | disable]
[enable | disable]
[replace | drop | keep]
[default | user_define <string 32> ]
{ipif [System]}
Used to configure the DHCP/BOOTP relay feature of the switch.
config dhcp_relay {hops <value 1-16> | time <sec 0-65535>} (1)
This command is used to configure the DHCP/BOOTP relay feature.
hops <value 1-16>  Specifies the maximum number of relay agent
hops that the DHCP packets can cross.
time <sec 0-65535>  If this time is exceeded; the Switch will not
relay the DHCP packet.
Only Administrator-level users can issue this command.
180
DHCP R
ELAY
20
C
OMMANDS