D-Link xStack DES-3200 Series Reference Manual page 252

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
Example usage:
To add the default static address 10.48.74.121, with a metric setting of 1, to the routing table:
DES-3200-28:4#create ipv6route default System 3FFC::1
Command: create ipv6route default System 3FFC::1
Success.
DES-3200-28:4#
delete ipv6route
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an IPv6 static route:
DES-3200-28:4#delete ipv6route default 3FFC::1
Command: delete ipv6route default 3FFC::1
Success.
DES-3200-28:4#
show ipv6 nd
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the interface's information:
Used to delete an IPv6 route.
delete ipv6route [[default] [<ipif_name 12> <ipv6addr>| all]
This command is used to delete an IPv6 static route. If the next hop is a
global address, it is not necessary to indicate the interface name. If the
next hop is a link local address, then the interface name must be
specified.
default – Specifies the default route.
<ipv6addr>  Specifies the next hop address for the default route.
all  All static created routes will be deleted.
Only Administrator-level users can issue this command.
Used to display the interface's information.
show ipv6 nd {ipif <ipif_name 12>}
This command is used to display the IPv6 ND related configuration.
<ipif_name>  The name of the interface.
Only Administrator-level users can issue this command.
247