Dos Prevention Commands - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The DoS Prevention commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
config dos_prevention
dos_type
show dos_prevention
clear dos_prevention
counters
enable dos_prevention
trap_log
disable dos_prevention
trap_log
Each command is listed, in detail, in the following sections:
D S P
O
Parameters
[ {land_attack | blat_attack | smurf_attack | tcp_null_scan |
tcp_xmascan | tcp_synfin | tcp_syn_srcport_less_1024} (1) |
all] {action [ drop | mirror <port> {priority <value 0-7> |
rx_rate [ no_limit | <value 64-1024000> ] } ] | enable |
disable ]} (1)
{land_attack | blat_attack | smurf_attack | tcp_null_scan |
tcp_xmascan | tcp_synfin | tcp_syn_srcport_less_1024}
{land_attack | blat_attack | smurf_attack | tcp_null_scan |
tcp_xmascan | tcp_synfin | tcp_syn_srcport_less_1024}
377
C
REVENTION
45
OMMANDS