D-Link xStack DES-3200 Series Reference Manual page 325

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
DES-3200-28:4#disable vlan_trunk
Command: disable vlan_trunk
Success.
DES-3200-28:4#
config vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a VLAN Trunk port:
DES-3200-28:4#config vlan_trunk ports 1-5 state enable
Command: config vlan_trunk ports 1-5 state enable
Success.
DES-3200-28:4#
To configure a VLAN Trunk port if Port 6 is LA-1 member port; port 7 is LA-2 master port.
Used to configure a port as a VLAN trunk port.
config vlan_trunk ports [<portlist>|all] | state [enable|disable]
This command is used to configure a port as a VLAN trunk port. By
default, none of the ports on the Switch are VLAN trunk ports. A VLAN
trunk port and a non-VLAN trunk port cannot be grouped as an
aggregated link. To change the VLAN trunk setting for an aggregated
link, the user must apply the command to the master port. However, this
setting will disappear as the aggregated link is destroyed, and the VLAN
trunk setting of the individual port will follow the original setting of the
port.
If the command is applied to link aggregation member port excluding the
master, the command will be rejected.
The ports with different VLAN configurations are not allowed to form an
aggregated link. However, if they are specified as VLAN trunk ports, they
are allowed to form an aggregated link.
For a VLAN trunk port, the VLANs on which the packets can be by
passed will not be advertised by GVRP on that particular port. However,
since the traffic on these VLANs are forwarded, this vlan trunk port
should participate the MSTP instances corresponding to these VLAN.
<portlist>  Specifies the list of ports to be configured.
enable  Specifies that the port is a VLAN trunk port.
disable  Specifies that the port is not a VLAN trunk port.
Only Administrator-level users can issue this command.
320