Dhcp Local Relay Commands - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The DHCP Local Relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config dhcp_local _relay
enable dhcp_local _relay
disable dhcp _local_relay
show dhcp _local_relay
Each command is listed, in detail, in the following sections.
config dhcp_local_relay vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable DHCP local relay for the default VLAN:
DES-3200-28:4#config dhcp_local_relay vlan default state enable
Command: config dhcp_local_relay vlan default state enable
Success.
DES-3200-28:4#
enable dhcp_local_relay
Purpose
Syntax
Description
Parameters
DHCP L
Parameters
vlan[<vlan_name 32> | vlanid <vidlist> ] state [enable |
disable]
Used to enable or disable the DHCP local relay function for a specified
VLAN.
config dhcp_local_relay vlan [<vlan_name 32> | vlanid <vidlist>] state
[enable | disable]
This command is used to enable or disable the DHCP local relay function
for a specified VLAN. When DHCP local relay is enabled for the VLAN,
the DHCP packet will be relayed in broadcast way without change of the
source MAC address and gateway address. DHCP option 82 will be
automatically added.
<vlan_name 32>  The name of the VLAN to be enabled DHCP local
relay.
<vidlist>  Specifies a range of VLAN IDs to be configured.
state  Enable or disable DHCP local relay for specified vlan.
Only Administrator-level users can issue this command.
Used to enable the DHCP local relay function on the Switch.
enable dhcp_local_relay
This command is used to globally enable the DHCP local relay function
on the Switch.
None.
OCAL
312
36
R C
ELAY OMMANDS