D-Link xStack DES-3200 Series Reference Manual page 463

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
show cfm fault
Purpose This command is used to show the MEPs that have faults.
Syntax show cfm fault { md <string 22> { ma <string 22> } }
Description This command displays all the fault conditions detected by the MEPs contained in the specified MA
or MD.
This display provides the overview of the fault status by MEPs.
Parameters ma <string 22> - The name of the maintenance association (MA) to view faults for MEPs.
md <string 22> - The name of the maintenance domain (MD) to view faults for MEPs.
Restrictions None.
Example usage
To view all MEP faults:
DES-3200-28F:4# show cfm fault
Command: show cfm fault
MD Name
----------- ----------- ----- ---------------------------
op_domain
DES-3200-28F:4#
show cfm port
This command is used to show MEPs and MIPs created on a port.
Purpose
Syntax show cfm port <port> {level <int 0-7> | direction [ inward | outward ] | vlanid <vlanid 1-4094>}
Description This command is used to show the MEPs and MIPs created on a port.
Parameters port <portlist> - The port for which to display CFM configuration.
level <int 0-7> - Setting level of the MD to be shown. If not specified, all levels are shown.
direction – The direction of the MEP to be displayed.
inward - Inward facing (up) MEP only are displayed.
outward - Outward facing (down) MEP only are displayed.
If not specified, both directions and the MIP are shown.
vlanid <vlanid 1-4094> - VLAN identifier for settings displayed. If not specified, all VLANs are
shown.
Restrictions None.
MA Name MEPID
op1 1
Status
Cross-connect CCM Received
458