Mac Notification Commands - D-Link DES-3010F Command Line Interface Manual

The MAC notification commands in the Command Line Interface (CLI) are listed, in the following table, along with their
appropriate parameters.
Command
enable mac_notification
disable mac_notification
config mac_notification
config mac_notification ports
show mac_notification
show mac_notification ports
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable MAC notification without changing basic configuration:
disable mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable MAC notification without changing basic configuration:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
{interval <int 1-2147483647> | historysize <int 1-500>
[<portlist> | all] [enable | disable]
<portlist>
Used to enable global MAC address table notification on the
Switch.
enable mac_notification
This command is used to enable MAC address notification without
changing configuration.
None.
Only Administrator-level users can issue this command.
DES-3026:4#enable mac_notification
Command: enable mac_notification
Success.
DES-3026:4#
Used to disable global MAC address table notification on the Switch.
disable mac_notification
This command is used to disable MAC address notification without
changing configuration.
None.
Only Administrator-level users can issue this command.
MAC N
OTIFICATION
145
23
C
OMMANDS