Arp Commands - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
create arpentry
config arpentry
delete arpentry
show arpentry
config arp_aging time
clear arptable
Each command is listed, in detail, in the following sections.
create arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DES-3200-28:4#create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DES-3200-28:4#
config arpentry
Purpose
Syntax
Description
Parameters
Parameters
<ipaddr> <macaddr>
<ipaddr> <macaddr>
{[<ipaddr> | all]}
{ipif [System] | ipaddress <ipaddr> | static}
<value 0-65535>
Used to make a static entry into the ARP table.
create arpentry <ipaddr> <macaddr>
This command is used to enter an IP address and the
corresponding MAC address into the Switch's ARP table.
<ipaddr>  The IP address of the end node or station.
<macaddr>  The MAC address corresponding to the IP address
above.
Only Administrator-level users can issue this command. The Switch
supports up to 255 static ARP entries.
Used to configure a static entry in the ARP table.
config arpentry <ipaddr> <macaddr>
This command is used to configure a static entry in the ARP Table.
The user may specify the IP address and the corresponding MAC
address of an entry in the Switch's ARP table.
<ipaddr>  The IP address of the end node or station.
<macaddr>  The MAC address corresponding to the IP address
239
27
ARP C
OMMANDS