D-Link xStack DES-3200 Series Reference Manual page 27

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
disable web
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable HTTP:
DES-3200-28:4#disable web
Command: disable web
Success.
DES-3200-28:4#
save
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To save the Switch's current configuration to non-volatile RAM:
DES-3200-28:4#save config
Command: save config
Saving all configurations to NV-RAM...... Done.
Success.
DES-3200-28:4#
Used to disable the HTTP-based management software on the
Switch.
disable web
This command disables the Web-based management software on
the Switch.
None.
Only Administrator-level users can issue this command.
Used to save changes in the Switch's configuration to non-volatile
RAM.
save {[config|log|all]}
This command is used to enter the current switch configuration into
non-volatile RAM. The saved switch configuration will be loaded into
the Switch's memory each time the Switch is restarted.
config – Used to save the current configuration to a file.
log – Used to save the current log to a file. The log file cannot be
deleted.
all – Save changes to currently activated configurations and save
log. If no keywords are specified, save the changes to the
configuration. If there are no keywords specified, the changes will be
saved to the configuration.
Only Administrator-level users can issue this command.
22