D-Link xStack DES-3200 Series Reference Manual page 405

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
show loopdetect ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display loopback detection configuration of port 1-9 under port-based mode:
DES-3200-28:4#show loopdetect ports 1-9
Command: show loopdetect ports 1-9
Port
------
1
2
3
4
5
6
7
8
9
Used to display the loopback detection configuration per port on the Switch.
show loopdetect ports [ <portlist> | all ]
This command will display the Switch's current per-port loop-detect configuration and
status.
<portlist> – Specifies a range of ports to be configured.
all – To set all the ports in the system, use the all parameter.
None.
Loopdetect State
------------------
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Loop Status
----------
Normal
Normal
Normal
Loop
Normal
Normal
Normal
Normal
Normal
400