Appendix C - Radius Attributes Assignment - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The RADIUS Attributes Assignment on the DES-3200 is used in the following modules: 802.1X (Port-based and Host-based),
and MAC-based Access Control.
The description that follows explains the following RADIUS Attributes Assignment types:

Ingress/Egress Bandwidth

802.1p Default Priority

VLAN

ACL
To assign Ingress/Egress bandwidth by RADIUS Server, the proper parameters should be configured on the RADIUS Server.
The tables below show the parameters for bandwidth.
The parameters of the Vendor-Specific attributes are:
Vendor-Specific Attribute
Vendor-ID
Vendor-Type
Attribute-Specific Field
If the user has configured the bandwidth attribute of the RADIUS server (for example, ingress bandwidth 1000Kbps) and the
802.1X authentication is successful, the device will assign the bandwidth (according to the RADIUS server) to the port. However,
if the user does not configure the bandwidth attribute and authenticates successfully, the device will not assign any bandwidth to
the port. If the bandwidth attribute is configured on the RADIUS server with a value of "0" or more, than the effective bandwidth
(100Mbps on an Ethernet port or 1Gbps on a Gigabit port) of the port will be set to no_limited.
A C - RADIUS A
PPENDIX
Description
Defines the vendor.
Defines the attribute.
Used to assign the bandwidth
of a port.
TTRIBUTES
Value
171 (DLINK)
2 (for ingress
bandwidth)
3 (for egress
bandwidth)
Unit (Kbits)
524
A
SSIGNMENT
Usage
Required
Required
Required