D-Link xStack DES-3200 Series Reference Manual page 144

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
config cos tos value
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Configure the TOS 5 to the traffic class 1 mapping:
DES-3200-28:4#config cos tos value 5 class 1
Command: config cos tos value 5 class 1
Success.
DES-3200-28:4#
show cos tos
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the TOS to traffic class mapping of the TOS 5:
DES-3200-28:4#show cos tos value 5
Command: show cos tos value 5
TOS value
-------------------------------------------
5
DES-3200-28:4#
Used to map the ToS value in the IP header of incoming packets to
one of the four hardware queues available on the Switch.
config cos tos value <value 0-7> [class <class_id 0-3>]
This command is used to configure ToS to traffic class mapping.
<value 0-7>  The ToS value of incoming packet that you want to
associate with the traffic class.
<class_id 0-3>  The number of the Switch's hardware priority
queue. The Switch has four hardware priority queues available.
They are numbered between 0 (the lowest priority) and 3 (the
highest priority).
Only Administrator-level users can issue this command.
Used to show TOS value to traffic class mapping.
show cos tos {value <value 0-7>}
This command is used to display the information of ToS to traffic
class mappings.
<value 0-7>  The TOS value of the incoming packet. If no
parameter is specified, all the ToS values to traffic class mappings
will be shown.
None.
Class
2
139