Subaru 2009 IMPREZA Service Manual page 3359

LAN SYSTEM (DIAGNOSTICS)
9. USER CUSTOMIZING
1) On «Main Menu» display, select {Each System Check}.
2) On «System Selection Menu» display, select {Integ. unit mode}.
3) On «Integ. unit mode failure diag» display, select {Unit Customizing}.
4) Change the setting with UP/DOWN key and set with the [OK] key.
• List of User Customizing item
Data
Off delay time
Rr defogger op. mode
Security Alarm Setup
Impact Sensor Setup
Alarm delay setup
Lockout prevention
Impact sensor (OP)
Answer-back buzzer setup
Hazard answer-back setup
Ans.-back Buzzer
Initial keyless setting
Subaru Select Monitor
Initial set-
Customize setting
ting value
OFF
Long Short
Normal
Long
15 minutes
15 minutes
Continuous
ON
ON
OFF
ON
OFF
OFF
ON
ON
OFF
ON
ON
OFF
ON
OFF
OFF
ON
ON
OFF
ON
ON
OFF
ON
ON
OFF
—
—
Execution
LAN(diag)-26
Remarks
Delay time below can be selected by setting.
0 seconds
10 seconds
20 seconds
30 seconds
Automatically stops in 15 minutes after switch is turned to
ON.
Repeats active condition for 15 minutes and inactive condi-
tion for 2 minutes until switch is turned to OFF.
Security alarm (hazard, horn or siren) in active condition
Security alarm in inactive condition
Workable when Impact Sensor Setup is set to "ON". Impact
sensor function becomes activated.
Impact sensor in inactive condition. (Set to "OFF" in models
without sensors.)
After the keyless lock operation, the alarm monitor starts
after the following delay time has passed.
Delay time is 30 seconds.
Delay time is 0 second.
Lockout prevention in active condition. (The function does
not operate if safety knob is locked by hand.)
Lockout prevention in inactive condition
Vehicle is controlled in impact sensor equipped mode.
(Make sure to set to "OFF" for models without the impact
sensor. When set to "ON" hazard, horn or siren will operate
after doors are locked by the keyless entry system opera-
tion (Alarm monitor start).)
Vehicle is controlled in no impact sensor mode.
Workable when answer-back buzzer setup is set to "ON".
When lock/unlock is selected by keyless entry system oper-
ation, hazard answer-back buzzer operates.
When lock/unlock is selected by keyless entry system oper-
ation, answer-back buzzer does not sound.
Workable when hazard answer-back setup is set to "ON".
When lock/unlock is selected by keyless entry system oper-
ation, hazard answer-back buzzer operates.
When lock/unlock is selected by keyless entry system oper-
ating, answer-back buzzer does not sound.
Vehicle is controlled in answer-back buzzer equipped
mode.
Vehicle is controlled in answer-back buzzer non-equipped
mode. (Make sure to set to "OFF" in models without answer
back buzzers.)
Settings of keyless entry system are initialized. (No. 2: 30
sec., No. 11: ON, No. 12: ON, No. 13: ON, No. 14: ON)
—