Subaru 2009 IMPREZA Service Manual page 3351

LAN SYSTEM (DIAGNOSTICS)
Items to be displayed
lock actuat. LOCK output
All seat UNLOCK output
D-seat UNLOCK output
R gate/trunk UNLK output
R wiper output
Shift Lock Solenoid
Key locking output
wiper deicer output
Hazard Output
Keyless Buzzer Output
Horn Output
D-belt warning light O/P
P-belt warning light O/P
Illumination lamp O/P
Room lamp output
key illumi. lamp o/p
Immobilizer lamp output
Keyless operation 1
Keyless operation 2
CC Main Lamp
CC Set Lamp
SPORT Lamp
SPORT Blink
Subaru Select Monitor
Unit of measure
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
ON/OFF CAN data output value
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit
ON/OFF
Body integrated unit input
Regist./Normal
Body integrated unit input
Deletion/Normal
ON/OFF CAN data input value
ON/OFF CAN data input value
ON/OFF CAN data input value
Blink/OFF CAN data input value
LAN(diag)-18
Remarks
ON when LOCK signal is output
output value
ON when unlock signal is output
output value
ON when unlock signal is output
output value
ON when rear gate/trunk unlock signal is
output value output
ON when rear wiper motor is operating
output value
ON when shift lock solenoid is operating
output value (only AT)
With ignition switch ON and in other than
output value the shift P range, with key in switch ON
ON when wiper deicer relay is operating
output value
ON when answer-back signal is received or
output value when hazard is operating
ON when lock/unlock signal is received
output value
ON when security warning is operating
output value
ON when ignition switch is turned to ON,
and buckle switch is turned off
ON when ignition switch is turned to ON,
occupant is seated, and buckle switch is
output value
turned OFF
ON when illumination is illuminated
output value
ON when keyless lock/unlock signal is
received (when keyless switch connector is
output value
removed)
ON when key illumination light is illuminated
output value
ON when immobilizer pilot light blinks
output value
When keyless is registered
value
When keyless registration is deleted
value
Cruise control switch ON
Reception from ECM and transmission to
combination meter
ON when cruise control vehicle speed is
set
Reception from ECM and transmission to
combination meter
SPORT mode switch ON
Reception from TCM and transmission to
combination meter
(only AT)
Blinks when there is an AT failure
Reception from TCM and transmission to
combination meter
(only AT)
Note