Subaru 2009 IMPREZA Service Manual page 3358

9) Perform the Factory or Market setting. On the
«ECM customizing" display screen of Subaru Se-
lect Monitor, select the {Factory or Market setting}.
10) Change the mode from Factory to Market and
then turn the ignition switch to OFF.
11) Change the Subaru Select Monitor system se-
lection to «Immobilizer» to register the immobilizer
key. (models with immobilizer)
12) Perform the operation according to the "PC ap-
plication help for Subaru Select Monitor".
13) When key registration is completed, "Do you
want to register remote engine start?" is displayed.
Perform registration only for equipped models.
14) Perform the User Customizing.
<Ref. to LAN(diag)-26, USER CUSTOMIZING,
OPERATION, Subaru Select Monitor.>
NOTE:
For details concerning the operation procedure, re-
fer to "PC application help for Subaru Select Moni-
tor".
7. CLEAR MEMORY MODE
1) On «Main Menu» display, select {Each System
Check}.
2) On «System Selection Menu» display, select {In-
teg. unit mode}.
3) Press the [OK] key after the information of body
integrated unit type is displayed.
4) On «Integ. unit mode failure diag» display, select
{Clearing Memory} and press the [OK] key.
Display
Clear Memory ?
5) When "Done" is shown on the display screen,
turn the ignition switch to OFF.
NOTE:
For details concerning the operation procedure, re-
fer to "PC application help for Subaru Select Moni-
tor".
8. FREEZE FRAME DATA
NOTE:
• Data stored at the time of trouble occurrence is
shown on the display.
• Freeze frame data will be memorized maximum
to 20.
• If freeze frame data is not stored in memory cor-
rectly (caused by low power supply of body inte-
grated unit), DTC will be displayed with "?" on the
head of it in the Subaru Select Monitor display. This
shows it may be an unreliable reading.
Subaru Select Monitor
Contents to be monitored
Clear function of DTC and
freeze frame data
LAN(diag)-25
LAN SYSTEM (DIAGNOSTICS)