Subaru 2009 IMPREZA Service Manual page 3360

Data
Initial button setting
Passive Alarm
Door open warning
Dome Light Alarm Setting
Map Light Setting
Belt Warning Switch
5) After setting, make sure that the setting changed in the {Current Data Display & Save} is same as vehicle
equipment.
CAUTION:
• The above settings must match the actual vehicle equipment.
• Do not change settings except for setting above while setting the functions.
• Be sure not to change Factory or Market setting except when installing a new body integrated unit.
NOTE:
For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".
10.FUNCTION CHECK
In order to check the body integrated unit function,
inspect the body integrated unit and actuator using
Subaru Select Monitor without operating switches.
1) On «Main Menu» display, select {Each System
Check}.
2) On «System Selection Menu» display, select {In-
teg. unit mode}.
3) On «Integ. unit mode failure diag» display, select
{Function check}.
4) Select the item to be operated on the «Function
check» display screen with "UP/Down key" and
press the [Next] button.
FUNCTION CHECK
HEATER COCK VALVE OUTPUT
DOOR LOCK ACTUATOR LOCK OUTPUT
ALL SEAT UNLOCK OUTPUT
HORN OUTPUT
R GATE/TRUNK UNLK OUTPUT
DOUBLE LOCK OUTPUT
SHIFT LOCK SOLENOID
KEY LOCK OUTPUT
Subaru Select Monitor
Initial set-
Customize setting
ting value
—
—
Execution
ON
OFF
OFF
ON
ON
OFF
ON
OFF
OFF
ON
ON
OFF
ON
ON
OFF
LAN00018
LAN(diag)-27
Remarks
Settings of each function are initialized. (No. 1: Normal, No.
3: 15 min., No. 4: 15 min., No. 8: ON)
Setting only for North American models
If detecting door open for 30 minutes, room light, and key
ring illumination that are related to doors are turned off to
prevent battery run-out.
Room light, key illumination and door warning light is not
turned off.
The room light lights by being interlocked with the activation
of the alarm.
Illuminates in accordance with the door interlocked room
light. (model with sunroof)
When using normally
Stop the belt warning buzzer beep and warning light illumi-
nation.
5) Pressing [Next] starts, [End] cancels the opera-
tion and [OK] returns to the System Operation
Check Mode display screen.
NOTE:
If not equipped (based on area or condition), pro-
cess will not go on.
LAN SYSTEM (DIAGNOSTICS)
—