NEC Univerge SV8100 Features And Specifications Manual page 289

UNIVERGE SV8100
Program
Program Name
Number
11-10-34 Service Code Setup (for System
Administrator) – Set Caller ID
Refuse
13-02-01 Group Speed Dialing Bins
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
13-04-03 Speed Dialing Number and Name
– Transfer Mode
13-04-04 Speed Dialing Number and Name
– Transfer Destination Number
13-04-05 Speed Dialing Number and Name
– Incoming Ring Pattern
Caller ID – Flexible Ringing
Description/Comments
Enable/Disable the Caller ID
number (trunks) which are set in
Program 14-01-27.
Designate the starting bin number
the system uses for Group Speed
Dialing.
Enter the System and Group
Speed Dialing numbers and
names.
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
Define the ring tone for the caller
ID routed call.
Assigned Data
1
MLT, SLT

(default not assigned)
01~64

(default not assigned)
#
1~9, 0, ,
Pause (Press line key
1)
Recall/Flash (Press
line key 2)

@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
0 = Not Used
1 = Internal Dial

2 = Incoming Ring
Group (IRG)
(default = 0)
If Transfer mode is
(Refer to 13-04-03):
1 = Internal Dial Mode
#
1~9, 0, , , P, R, @

(Maximum 24
Characters)
2 = Incoming Ring

Group
0~100 (IRG Number)
P=Pause R=Recall
@= Additional Digits
when using ISDN
functionality
(default not assigned)
Incoming Ring Pattern
0 = Normal Pattern
1~4 = Tone Pattern
(1~4)
5~9 = Scale Pattern
(1~5)
10~13 = Tone Patterns
(5~8)
(default = 0)
Issue 11.0
Level
2 3

2 - 257