NEC Univerge SV8100 Features And Specifications Manual page 296

Issue 11.0
ISDN Compatibility
Line Preference
Long Conversation Cutoff
Night Service
Programmable Function Keys
Selectable Display Messaging
Warning Tone for Long Conversation
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
10-03-XX ETU Setup
11-11-13 Service Code Setup (for Setup/
Entry Operation) – Display
Language Selection for Multiline
Terminal
11-12-30 Service Code Setup (for Service
Access) – Specified Trunk
Answer
2 - 264
Description/Comments
Use program 10-03-XX to setup
and confirm the basic
configuration data for each blade.
This program represents different
data depending on the blade
installed in the slot. Please refer
the SV8100 Programming Manual
for a more detailed description of
this program.
Select the service code which can
be used at an extension to change
the displayed language on a
multiline terminal display.
If required, redefine the service
code used to answer a specific
trunk which is either ringing or on
hold.
UNIVERGE SV8100
Assigned Data
1
The assigned data
varies depending on
the blade installed in
the slot. Please refer
to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
MLT
(default = 678)
MLT, SLT
(default = 672)
Central Office Calls, Answering
Level
2 3


