NEC Univerge SV8100 Features And Specifications Manual page 202

Issue 11.0
Program
Program Name
Number
14-04-01 Behind PBX Setup
20-09-01 Class of Service Options
(Incoming Call Service) –
Second Call for DID/DISA/DIL/
E&M Override
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
20-13-05 Class of Service Options
(Supplementary Service) –
Intercom Off-Hook Signaling
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
24-02-13 System Options for Transfer –
Hook Flash Sending Timer When
the System Answers
Automatically
24-09-06 Call Forward Split Settings – Call
Forwarding Destination for CTX/
PBX for All Call, No Answer
24-09-07 Call Forward Split Settings – Call
Forwarding Destination for CTX/
PBX for Busy
2 - 170
Description/Comments
Indicate if the trunk is installed
behind a PBX (1) or not (0). There
is one item for each Night Service
Mode.
Turn Off or On an extension ability
to receive a second call from a
DID, DISA, DIL, or tie line caller.
With this option set to 1, the

destination extension must
be busy for a second DNIS
caller to ring through. If the
destination extension does
not have a trunk or CAP key
available for the second call
and a previous call is ringing
the extension but has not yet
been answered, the second
caller hears busy regardless
of this program setting.
Turn Off or On an extension ability
to have calls queued if a call rings
the extension when it is busy.
Turn Off or On an extension ability
to receive off-hook signals.
Allow a busy extension ability to
Manually (0) or Automatically (1)
receive off-hook signals.
Set the time the system waits
before sending the hookflash for
the Centrex Transfer after
answering the call.
Assign Call Forwarding Type and
the destination numbers for CTX/
PBX all call, no answer.
Assign Call Forwarding Type and
the destination numbers for CTX/
PBX busy calls.
UNIVERGE SV8100
Assigned Data
1
0 = Stand Alone
(Trunk)
1 = Behind PBX (PBX)

2 = Not Used
3 = CTX assume 9
(default = 0)
0 = Off
1 = On
(default = 1 for
COS 1~15)

0 = Off
1 = On

(default = 1 for
COS 1~15)
0 = Off
1 = On

(default = 1 for
COS 1~15)
0 = Off
1 = On

(default = 1 for
COS 1~15)
0~64800 (seconds)
(default = 2)
1~9, 0, #, , R, @

(Up to 24 digits)
(default not assigned)
1~9, 0, #, , R, @

(Up to 24 digits)
(default not assigned)
Call Forwarding – Centrex
Level
2 3
