NEC Univerge SV8100 Features And Specifications Manual page 1895

UNIVERGE SV8100
Conditions
If NEC Sonic View IP Recorder 1.0 has been installed previously, then the SonicView IP

Recorder 1.0 must be uninstalled prior to installing NEC SonicView recorder 2.0.
The PC hosting the recording engine component should be on the same subnet as the PBX

for it to capture calls. Unless this configuration is made, no calls will be recorded.
A Vista "Master Administrator" account ("Administrator") is required to install the

application. The user must enable the Vista Master Administrator account and log into this
account to perform the installation. The Apache Tomcat web server, Apache Derby
Database server and Recording Engine will not be installed correctly in non-master
administrator accounts.
A single-/multi-port managed switch with port mirroring setup is mandatory to enable call

cap-turing over the network. The server hosting the recording engine should be connected
to a managed switch (customer provided) such that the PBX's traffic mirrored to the port on
which the recording engine server is connected.
Recording Digital terminals is now possible after adding the NEC-4 port digital call logging

device via USB to the system that has the Digital recorder installed. See the SonicView
Installation and Configuration guide for detailed information.
Recording of internal Digital calls will result in no direction, name or number indication. Only

the Receiving Terminal will show name and number. Recording of Digital terminals that
have been assigned to trunk configuration will result in no number indication. Outgoing or
incoming trunk calls with a Digital terminal will not show direction.
Recording both IP and Digital terminals on the same server requires an additional NIC

(network interface card).
Default Settings
Not Installed
System Availability
Terminals
NEC DT700 series (IP) Terminals – NEC SonicView Recorder
NEC DT300 series (Digital) Terminals- NEC SonicView Recorder
Voice Call Recording
Issue 11.0
2 - 1863