Removing And Installing Gear Selector Cable And Gate Selector Cable - Volkswagen Golf Variant 2007 Service Manual

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
6-speed manual gearbox 02S - Edition 07.2009
Clip -A- holds cables and heat shield together in position.
– Install cable support bracket on gearbox and tighten bolts to
specified torques ⇒ Item 6 (page 70)
The holes in the cable end-pieces have different diameters.
Allocation of cable end-pieces
– Spread a small quantity of grease -G 000 450 02- on pins
-arrows- of gearbox selector lever -1- and relay lever -2-.
– Renew securing clips -3- and -4- each time they are removed.
– Secure gear selector cable with securing clip -3- and gate se‐
lector cable with securing clip -4-.
Cable end-piece to plastic relay lever
– Fit relay lever and cable end-piece together
– Insert gate selector cable in cable end-piece.
Continued for all selector mechanisms
– Install centre console ⇒ General body repairs, interior; Rep.
Gr. 68 ; Compartments, covers and trims .
– Install gaiter with selector knob and noise insulation
⇒ page 61 .
– Install heat shield.
– If removed, reinstall underbody panels ⇒ General body re‐
pairs, exterior; Rep. Gr. 50 .
– Assemble exhaust system free of tension and attach tunnel
cross member ⇒ Rep. Gr. 26 ; Removing and installing parts
of exhaust system .
Adjust selector mechanism
– If removed, install complete air filter housing ⇒ Rep. Gr. 23 ;
Repairing diesel direct injection system or ⇒ Rep. Gr. 24 ;
Repairing injection system
– Follow procedure after connecting battery ⇒ Electrical system;
Rep. Gr. 27 ; Battery; Disconnecting and connecting battery .
2.10 Removing and installing gear selector
cable and gate selector cable
2.10.1 Removing
– Remove selector mechanism
78
Rep. Gr.34 - Controls, housing
.
⇒ page 72
⇒ page 73
⇒ page 80 .
⇒ page 75 .
.