Volkswagen Golf Variant 2007 Service Manual page 73

– Move gate selector lever back to stop (opposite from mounting
holes for gear and gate selector cable) -arrow 1-.
– Grease ball stud.
– Press ball stud into gate selector lever -arrow 2-.
• Guides -A- and tabs -B- are not allowed to be damaged.
– Place selector housing with gear lever guide into larger recess
-arrow- in thrust piece -T10083- .
• The gear lever guide must project from the selector housing
up to the stop.
– Lift upper end -A- of compression spring over pin of gate se‐
lector lever
• Use a new ball socket -B-.
– Grease ball socket and bearing ball of gear lever guide.
– Press ball socket onto bearing ball of gear lever guide up to
stop.
– Remove selector housing from thrust piece -T10083- .
– Insert lower end -C- of compression spring into guide.
– Lift upper end -A- of compression spring over pin of gate se‐
lector lever into guide.
– Press ball socket into selector housing -arrows-.
• All locking lugs must clip in.
– Attach gear lever, gear selector cable, gate selector cable and
base plate ⇒ page 65
– Install selector mechanism
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
.
⇒ page 75 .
6-speed manual gearbox 02S - Edition 07.2009
2. Repairing selector mechanism
69